2007-m35-won-t-start-t613922.html#p6733373 2007-m35-won-t-start-t613922.html#p6735348 It does sound like my symptoms as well so I think you are right, I should look at the i-key unit first instead of BCM. Unfortunate as that unit is not nearly as common as used BCMs and is much more expensive. Thanks for your help putting me onto this thrack first In this scenario, placing the key fob against the push-start button may temporarily solve the problem and help you start the car. However, this trick won't work if the battery is completely drained. A completely dead battery might result from prolonged inactivity, transforming a low battery situation into a no-battery scenario. 2. Damaged Key Fob BUT WONT START. The TCM fuse will be #58 in the IPDM. The IPDM will be upside down forward of the left strut tower, I can't recall if the intake duct needs to be removed to access it like the gen2 but I think it does. You can find a location drawing here on page PCS-5: Re: 2010 NISSAN ROGUE CRANKS. My Juke has almost 150,000 miles on it and it would not start this morning with the push button. In this video I describe how I got it started. In this video I describe how I got it started 2 NG OK No crank, No start OK DLK-270 3 NG NG No crank, No start No crank, No start DLK-272 4 OK OK No crank, No start No crank, No start SEC-135 5 OK NG No crank, No start OK SEC-136 6 Poor range OK OK OK DLK-274 Intelligent key problems are grouped by whether they occur with both or only one key (Table 1 or 2, respectively). Hi, I own a 2015 infiniti Q40 and my key fob stopped working the buttons on the fob still work it just wont start without me putting the key fob in the key slot on the left of the steering wheel. i replaced the batteries and it still did not work and i tried to put the fob on the start button and turn it on with the key and it still doesnt work and it does not give me any messages that say no Note that the best place to keep the key fob is in this compartment, so it does not drain the car's battery. Once you find this, look for a small button that says "program" on it. It is the start button that you will press to program the push-start key fob. Step 2 - Press and Hold Any Button on Your Fob SQE8r9.

nissan qashqai won t start no key detected